FLUNA TEC | FLUNA GUN COATING 100ml Liquid
Fluna GunCoating is a ceramic high performance coating for all kinds of firearms and knives. Despite its extreme lubricating properties Fluna GunCoating is free of residue. It forms an invisible, dry film on the weapon and increases the gliding properties of moving weapon parts. Hard, metallic sounds of rubbing parts are reduced considerably. Fluna GunCoating forms a firm unit with the surface, does not run off and is thus a long-lasting protection against corrosion. Fluna GunCoating can be applied on all surfaces such as steel, plastic, polished wood, gold and silver ornaments, colour case hardenings, cast and rubber. Fluna GunCoating smoothes out microscopic cracks and striae and permanently the treated surfaces polishes. Wear is thus reduced to a minimum, gun efficiency increased. Fluna GunCoating is already effective at first application.
- Suitable for all kinds of firearms and knives
- Can be applied on every surface
- Transparent, no-residue, non-greasy coating
- Very good gliding properties, long-lasting effect
- Resistant to salt and fresh water
- Economical in use
- High temperature resistance from -40°C to +750°C
- No formation of resin, no gluing together, colourless and odourless
- Simplifies cleaning of weapon
- PTFE free and silicone free
As a basic principle, Fluna GunCoating is applied on a cleaned weapon. Metal parts should be degreased prior to the application so that the ceramic particles can directly cling to the metal. Spray a thin coat of Fluna GunCoating onto the surfaces and then distribute with a lintfree cloth so that a think, wet film covers the surface. Fluna GunCoating then dries automatically. At room temperature the coating is dried after about 30 minutes and completely hard after approximately two hours. When applied at the barrel the barrel must first be cleaned thoroughly. Then apply a thin coat of Fluna GunCoating with either cotton wool or a felt wad. For the application on larger surfaces we recommend the spray. For the application on small parts and the adjustment of the trigger the liquid product in the dropper bottle is recommended.